|
|
| |
|
 | Search: |
|
|
 |
|
|
RELAY Click board features two G6D1AASI-5DC power PCB relay modules as well as two screw terminals. It communicates with the target microcontroller via mikroBUS PWM (RL1) and CS (RL2) pins. A green LED diode indicates the presence of power supply. Controls up to 5A, 250V AC/30V DC loads. The board is designed to use a 5V power supply only, however communication lines voltage level can be in the range of 1.8V to 5V as on-board transistors are used to drive the relays by current sinking. |
|
|
|
|
 |
|
|
The Relay4 Board is a small-sized board with 4 Relays (each supports currents up to 16A). It also contains ULN2803 (high-current Darlington arrays) for driving relays and an IDC10 connector for easy connection with a development or prototype board (an IDC10 cable is included). |
|
|
|
|
|
|
Relay 2 click carries two LCA717 single-pole, OptoMOS solid state relays and two screw terminals for connecting the wiring. These relays have a load current of 2A, low maximum on-resistance of just 0.15 Ohms, and a blocking Voltage of 30V. The LCA717 have optically coupled outputs that use the patented OptoMOS technology. Solid state relays enable fast, silent and bounce-free switching. Each relay is coupled with an onboard signal LED. The board is designed to use a 3.3V power supply only. |
|
|
|
|
|
|
Signal Relay click can be used for ON/OFF control in various devices. It carries four ultra-small GV5-1 PCB relays from Omron and runs on a 5V power supply. Signal Relay click communicates with the target MCU over the following mikroBUS pins: AN, RST, CS and PWM. |
|
|
|
|
|
|
